Slot and plug welding symbols

Unit 17 Plug and Slot Welds 0010 0010 Symbol A-A Desired weld A-A 235 Symbol Desired weld student submitted image, transcription available

Slot and plug welding symbols Plug welds are circular welds made through one member of a lap or tee joint joining that member to the other The weld may or may not be made through a hole in

Unit 17 Plug and Slot Welds 0010 0010 Symbol A-A Desired weld A-A 235 Symbol Desired weld student submitted image, transcription available

slot op raam Slot weld is also shown in the figure above It is quite similar to the plug weld, except that the hole is not circular, it is an elongated hole

The slot weld symbol is the same that is used for plug welds The symbol will not show a diameter symbol before the size however The size of the weld will be

slot demo play Must watch lecture for all ESE and GATE aspirant In this lecture Abhinav Kumar (UPSC ESE AIR

Vehicle makers may have recommendations for plug weld hole size and location If they do not, holes should be 8 millimeters or 516 inch if the